Operator’s manual
Rotary tedder P4 – 471 and P4 – 531
Rotary tedder P6 – 651 and P6 – 771
- 20 -
a)
recommended operating position
b) not recommended operating position
At the workplace and after setting the tedder, in the operating position must be:
connect PTO shaft between tractor and tedder,
by means of 3-point linkage by lowering or raising adjust the inclination of the tedder
(recommended around 15°) (
Fig. 17
),
Fig. 17.
Rotary tedder in working position
SaMASZ tedders feature high-range spreading angle adjustment.
Fig. 18
provides
recommended and not recommended operating position. Setting of drive wheel axis nearer the
finger at the ground (
Fig. 18a
) results in better ground linking and prevents its piercing into the
ground. Too far a setting of wheel axis from the finger in operating position shall cause less
effective adapting of any unevenness (
Fig. 18b
).
Fig. 18.
Tedder in operating position
when operating catch pin
S1
with upper link should get leaned on the frontal edge of one eye,
and vertical pin
S2
must get leaned on the rear edge of the other eye (
Fig. 19a
),
it is allowable to set the machine as shown on
Fig. 19b
when operating on an even ground catch
pin
S1
with upper link should be in opening
O
, and catch pin
S2
must be in the middle of the
eye. Such setting results in limiting the ground following range,
