31
OPERATOR’S MANUAL
TRAILED ROTARY TEDDER
P10-1200
WARNING!
Use only the tines recommended by the manufacturer.
WARNING!
Before you change the tines check rotor turns (
6.2.
Daily maintenance
Every day after work please carry out the following maintenance:
❑
check all visible units and parts and their connections; tighten all loose bolts and nuts and replace
all damaged and/or worn parts with new genuine ones,
❑
remove grass and mud,
❑
clean the tedder each day after working,
❑
check the rotors,
❑
grease PTO shaft tubes with STP grease,
❑
if necessary, lubricate the parts and units according to lubrication instructions (item 7).
6.3.
After-season maintenance and storing
It is recommended for the operator to wear protective gloves when performing maintenance works
.
At the end of the season the tedder should be cleaned, washed and dried. Carefully grease unpainted
surfaces and 3-point linkage pins. After that the following work should be carried out:
❑
remove any traces of rust and paint the area affected,
❑
check lubrication of intersecting axis gears (chapter. 7). If leaks occur, remove them immediately,
❑
periodically check the tedder and secure the moving parts with grease to prevent the tedder from
rust, which affects the proper functioning of the machine,
❑
regularly check hydraulic hoses. In case of damage or expiry replace with new ones. Expiry period
should not exceed 5 years.
The detached machine should be stored in standstill position, so it is supported onto a protected
support leg. It is recommended to store the set on paved ground, preferably in roofed places,
inaccessible to unauthorized personnel or animals.
6.3.1.
Restarting the machine after storing period
❑
Make sure that all nuts and screws are tightened with correct torque (
Tab. 3
).
❑
Make sure that all guards are installed in place.
❑
Lubricate the whole machine.
❑
Examine condition of tines, and if necessary, replace them with new ones.
❑
Examine pressure in tires.
