40
KDT
REAR DISC MOWER
OPERATOR’S MANUAL
Fig. 35a.
Rollers transmission guard
Fig. 35b.
Adjusting tension of transmission
toothed belt
Fig. 35c.
Conditioner roller transmission guard
Fig. 35d.
Adjusting tension of toothed belt for conditioner
roller transmission
6.11.3.
Daily maintenance
When you finish each day of operation carry out the following maintenance:
❑
check all visible parts and components and their connections; tighten all loose bolts and nuts and
replace all damaged and/or worn parts with new genuine ones,
❑
clean the mower, especially between discs and cutterbar, because grass with mud may damage
bearings in disc module,
❑
remove grass and mud, also from under the covers of the belt transmission of the conditioner /
rollers,
❑
check the cutterbar,
❑
grease PTO shaft tubes with STP grease,
❑
if necessary, lubricate the parts and components according to lubrication instructions (chapter7).
Parts which may cause risk to operator’s health and safety are as follows: damaged discs, missing or
damaged safety covers, worn or damaged hydraulic hoses, PTO shaft guides, worn knives and knife
holder pins.
O
S
N
N
O
S
