Programming Instructions
For SAM4S ER380/ER380M
www.hotpos.com.au
Contents:
Cash register
operation manual
Keys x 12
1 small roll of paper
Pre-Setup
Remove cash register from box
Ensure all packaging materials are fully removed
Remove the cardboard protectors from cash draw
Plug register into power
Turn power on at register
Turn key to REG position
Step 1 – General Setup
1. Lift and pull the paper cover from back
2. Remove any packaging material
3. Push the blue lever on top and lift
4. Remove paper from plastic
5. Place paper in register ensuring the paper is being feed from the bottom
6. Close lid
7. Tear off excess paper
8. Replace cover
: warning message will appear. Press red CLEAR button to remove warning.
press 1 on the grey numerical keys then press clerk button
Step 2(a) – Programming PLU button descriptions on the preset buttons )
1. Using the key marked P - turn to the
PGM
position
2. Enter
3 0 0
, and press
SUB TOTAL
key
3. Select the PLU you wish to program
(by either
Pressing one of the
PLU keys
on the
keyboard,
or
Entering the number of the PLU using the keypad and pressing the
PLU
key)
4. Overlay the Alpha keyboard and type your description and press the
X/TIME
key
5. Repeat steps 3 & 4 above for all your PLU descriptions
6. Press
CASH
when finished to save
Step 2(b) – Programming PLU descriptions for Barcode Scan items (optional if using
barcode scanner)
1.
Using the key marked P - turn to the
PGM
position
2.
Enter
3 0 0
, and press
SUB TOTAL
key
3. Select the PLU you wish to program by scanning the Product
4.
Overlay the Alpha keyboard and type your description and press the
X/TIME
key
5. Repeat steps 3 & 4 above for all your PLU descriptions
6. Press CASH when finished to save
V2.1
