Sam4s ER-180U Series, Service Manual

Page: 11 / 51

SAM4S ER-180U SERIES 3-1
3 Installation and Operation
WARNING: Before using Electronic Cash Register (ECR) for the first time, leave it powered ON in the
REG mode for
at least 24 hours.
This allows the MS-Lithium battery, which maintains the
ECR’s memory while the power is OFF, to charge fully.
3-1 Installation
3-1-1. Paper Roll Installation
1. Remove the printer cover.(Fig 3-1 (A),(B))
2. Open the housing clam cover and Insert the paper roll as shown.(Fig 3-1 (C), (D))
3. Pressing the housing clam cover.(Fig 3-1 (E))
4. Lay a cover on the side and press the FEED button.
5. Feed the leading edge of the paper in about 150mm and fold the tip in 20mm. (Fig 3-1 (F))
Insert the leading edge of the paper into the slot on the Spool Winding. (Fig 3-1 (G),(H))
6. Turn the Spool Winding in 2~3 turns. (Fig 3-1 (I))
7. Place the Spool Winding on the Paper Supply. If it loosen, turn to tighten it. (Fig 3-1 (J))
8. Replace the printer cover.(Fig 3-1 (K))
Figure 3-1. Paper Installation and Take-Up Spool Installation