en
56 / 108
7.5
Changing the basic settings for time and setpoint temperature
With this function, you can adjust the factory-set values for time and setpoint temperature to your require
ments.
These settings remain stored even after the appliance has been switched on and off at the customer's
electrical main switch.
The appliance must be
switched off
.
Three dots glow on the display.
Press the "P"
key.
Within 3 seconds, select the number for the "product key" by pressing the keys 1 to 4: E.g.
−
for products1-4, press the key "1, 2, 3 or 4" or
−
for products with two-digit numbers, e.g. "product key 12", press key 1 and immediately after that
key 2.
The time display flashes.
The number of the "product key" is briefly displayed.
For changing the time:
Within 10 seconds, press and hold down the "up"
or "down"
key.
First, the values are reduced or increased slowly, then rapidly. By pressing the key, the setting is re
duced or increased by one step respectively.
Within 10 seconds, press the "P"
key.
The set time has been stored.
The setpoint temperature display flashes.
For changing the setpoint temperature:
Within 10 seconds, press and hold down the "up"
or "down"
key.
First, the values are reduced or increased slowly, then rapidly. By pressing the key, the setting is re
duced or increased by one step respectively.
Storing the factory-set setpoint temperature:
Within 10 seconds, press the "P"
key.
If the "P"
was not pressed, the changed setpoint temperature is not stored and the setting proced
ure is automatically interrupted after 10 seconds.
+
-
3 sec.
10 sec.
10 sec.
10 sec.
10 sec.
Operating mode "Product keys"
