KL10RF
Installation and wiring guide
www.salus-controls.com Technical Helpline 00000 000000
L
N
1
2
L
N
1
2
L
N
1
2
L
N
1
2
OUT
IN
OPTIONAL UFH ZONE VALVE
FOR RADIATORS GROUPS
FUSE
FUSE
SUPPLIED CABLES
230V TO UFH PUMP
UNDERFLOOR HEATING MANIFOLD
1.5MM
2
CABLE (INSTALLER SUPPLIED)
1.5MM
2
CABLE (INSTALLER SUPPLIED)
1.5MM
2
CABLE
(INSTALLER SUPPLIED)
1.5MM
2
CABLE
(INSTALLER SUPPLIED)
13 AMP FUSED CONNECTION UNIT
FUSED AT 3 AMPS
230V
OPTIONAL
CYLINDER STAT
1.5MM
2
3 CORE
1.5MM
2
3 CORE
1.5MM
2
CABLE
OUT
IN
(INSTALLER SUPPLIED)
COLOURS ARE INDICATIVE ONLY.
EXTRA CONNECTIONS MAY BE REQUIRED
AS PER MANUFACTURERS INSTRUCTIONS
ZONE 1
+
+
+
+
+
+
+
+
+
-
-
-
-
-
-
-
-
-
ZONE 2
IN
HW CYLINDER
THERMOSTAT
HW MOTORISED VALVE
OVERHEAT STAT
UFH PUMP
BOILER ENABLE
UFH MOTORISED VALVE
OUT
IN OUT
IN OUT
BR EA N OR GR
BR EA N OR GR
L N E
ZONE 3
ZONE 4
ZONE 5
ZONE 6
ZONE 7
ZONE 8
L
N
1
2
L
N
L
N
L
N
L
N
L
N
L
N
THERMOSTAT NEUTRAL CONNECTIONS
THERMOSTAT LIVE CONNECTIONS
L
N
L
N
L
N
L
N
L
N
L
N
L
N
L
N
L
N
L
N
BATTERY POWERED
PROGRAMMABLE
ROOM THERMOSTAT
(MODEL VS20WRF)
OPTIONAL
HOT WATER TIMER
(MODEL VS10WRF
or VS20WRF)
MAINS POWERED
PROGRAMMABLE
ROOM THERMOSTAT
(MODEL VS10WRF)
BATTERY POWERED
PROGRAMMABLE
ROOM THERMOSTAT
MAINS POWERED
PROGRAMMABLE
ROOM THERMOSTAT
BATTERY POWERED
PROGRAMMABLE
ROOM THERMOSTAT
BATTERY POWERED
PROGRAMMABLE
ROOM THERMOSTAT
MAINS POWERED
PROGRAMMABLE
ROOM THERMOSTAT
(MODEL VS20WRF
L
N
1
2
(MODEL VS10WRF)
L
N
1
2
L
1
2
OPTIONAL
PROGRAMMABLE
ROOM THERMOSTAT
RADIATOR ZONE
L
N
1
2
RADIATOR ZONE
L
N
1
2
or VS20WRF)
2
2
1
3
4
8
6
5
9
FACTORY
FITTED
LINK
FACTORY
FITTED
LINK
FACTORY
FITTED
LINK
These instructions are applicable to the SALUS model
stated above.
Warning
This product must be fitted by a competent person, and
installation must comply with the guidance, standards and
regulations applicable to the city, country or state where the
product is installed. Failure to comply with the requirements
of the relevant guidance, standards and regulations could lead
to injury, death or prosecution.
Warning
Always isolate the AC Mains supply before installing or working
on any components that require 230 VAC 50Hz supply.
For PDF Installation guide please go to www.salus-controls.com
Meets the following EC Directives
• Electro-Magntic Compatibility directive 2004 / 108 / EC
• Low voltage Directive 2006/95/EC
Optional wireless
receiver RX10RF
7
Maintaining a policy of continued product development
S
ALU
S
Controls plc reserve the right to change
specification, design and materials of products listed on this installation guide without prior notice.
Issue Date: June 2014 Document Number 00106
iT600 Wiring Centre KL10RF 004_Layout 1 05/06/2014 15:24 Page 1
