37
Chapter 8 System Maintenance
8.1 Dust checking
The fusion splicer detects the dust on fiber, camera or objective by imaging, which
can influence the splicing result. This function can detect the dust on the optical
channel and judge whether it will influence splicing quality or not.
Operations
Choose [dust checking] in [system maintenance].
If fiber already set in the fusion splicer, take out the fiber and press [set] to start
dust checking.
If dust is found while checking, [executive failure] will be noted on monitor.
Clean the objective and perform dust checking again, until it shows [executive
completed].
Attention: if the dust still remains after cleaning, please contact the agent or
manufacture.
