Tel: 886. 909 602 109 Email: [email protected]
www.salukitec.com
49
3.6.3 < Speed >: Setting the Output Speed
Choose the < Offset & Expand> and enter the secondary submenu, as is shown in Fig.35.
<Slow>
the data output speed of channel CH1 & CH2 is 10 Hz
<Fast>
the data output speed of channel CH1 & CH2 is 312.5 kHz
3.7
[SAMPLE]
[SAMPLE] submenu is used to control the sampling and storage. There are 5 settings in this submenu, including <Step
Time>, <Length>, <Select>, <Trigger Mode> and <Sample Mode>, as is shown in Fig.36.
The setting of [SAMPLE] menu should cooperate with the keys in CONTROL area. In this case, [SAMPLE] can control
the sample to start, pause and reset.
Fig.36 [SAMPLE] Submenu
3.7.1 < Step Time >: Setting the Sampling Invertal
Setting the sampling time interval, range: 1ms to 100,000ms, collect one data at every step time.
3.7.2 < Length >: Setting the Sample Length
Setting the sample data length, range: 1 to 16384
When the data sampling is being executed, if the <Length> value is set smaller than the length of the current sampling,
sampling will stop immediately in single sample mode. But in the loop sample mode, sampling will start again from the
first point.
3.7.3 < Select >: Setting the Sampling Object
The <Select> secondary menu is shown in Fig.37.
