Tel: 886. 909 602 109 Email: [email protected]
www.salukitec.com
46
Fig.33 [SAVE/RECALL] Submenu
[SAVE/RECALL] menu is mainly used to save and recall the setting parameters and status. Users can save in <S1>,
<S2>, <S3> and <S4> according to their individual favorites. As is shown in Fig.33, <Save & Recall> choose <Save>,
<Channel> chooses <S1>, <Execute> choose <YES>, and then the current setting parameters and status will be saved in
<S1>. In this case, the current parameters and status can be save in <S1>. <Save & Recall> choose <Recall>, <Channel>
chooses <S1> and <Execute> choose <YES> to recall the archive. In this case, the data in <S1> can be recalled.
3.6
[CHANNEL OUTPUT]
Press [CHANNEL OUTPUT] button and enter the submenu as is shown in Fig.34.
Fig.34 [CHANNEL OUTPUT] Submenu
The two BNCs CH1 and CH2 can output R, X, Y and
θ
that users wanted by setting in the [CHANNEL OUTPUT]
submenu. The output offset and expand is set in <Offset & Expand>. In <Speed>, users can set the output rate of channel.
The calculation equation of output signal is:
1. When source is <R>, <X>, <Y>, <Rh1>, <Xh1>, <Yh1>, <Rh2>, <Xh2>, <Yh2> or <Noise>:
