Saluki S3601 Series, User Manual

Page: 31 / 140

31
Tel: 886.2.2175 2930 Email: sales@salukitec.com
www.salukitec.com
4.
Measurement Setting
This chapter will introduce how to make the measurement settings. Normally, following setting operations should be done during a
test. This chapter will introduce these operations in sequence.

Resetting Analyzer

Selecting Measure parameter

Setting frequency range

Setting signal power level

Sweep Setup

Selecting triggering mode

Setting data format and scale

Observing multi-Trace and enabling multichannel

Setting Analyzer display

Configure 4-port Measure
4.1.
Resetting Analyzer
4.1.1.
Reset state
When [Preset] key is pressed, the Analyzer will be returned to a default state which is known as reset state, and the reset state for
S3601 Series Vector Network Analyzer is set as follows:

Measure parameter: S11

Frequency setting:

Start frequency: 100kHz

Stop frequency: 3GHz/8.5GHz

CW Time: 2GHz

Power setting:

Measuring port power: 0dBm

Coupled port power: on Attenuation :

automatic attenuation Attenuation

value : 0dB

Sweep Setup:

Sweep type: linear frequency

Sweep time: automatic

Sweep spot number: 201

Segment Sweep Setup:

Number of started segment: 1

Start frequency: 100kHz