Tel: 886.909 602 109 Email: [email protected]
174
Section 3 Description of Signal Analysis Menu
1 Frequency menu
·[Center Freq]:
press [Freq]→[Center Freq], to select [GHz], [MHz], [kHz]
or [Hz] by number key on front panel or [↑] or [↓] key and spinning wheel in
frequency menu.
·[Special Notice]: in case of using [↑] or [↓] key and spinning wheel,
the frequency step is same with the set value of [Step Freq]. After
pressing [Step Freq Auto Man] to switch to [Step Freq Auto Man], it is
allowed to use the number key or [↑] or [↓] key and spinning wheel to
set the step frequency.
·[Span]:
press [Freq]→[Span], to activate the span sub-menu by using
number key, frequency unit or [↑] or [↓] key and spinning wheel. For
details, please refer to the description of [Span].
·[Special Notice]:
use [↑] or [↓] key and spinning wheel to change span
as per the step size of 1-2-5.
·[Start Freq]:
press [Freq]→[Start Freq], to use the number key on front
panel, frequency unit or [↑] or [↓] key and spinning wheel to set the Start
Freq.
·[Stop Freq]:
press [Freq]→[Stop Freq], to use the number key on front
panel, frequency unit or [↑] or [↓] key and spinning wheel to set the Stop
Freq.
·[Signal Std]:
press [Freq]→[Signal Std], to select a signal standard by
using [↑] or [↓] key and spinning wheel and call it by [Done] menu or
[Enter] key.For details, please refer to the dialog box menu.
·[Special Notice]: after the signal standard is loaded, the center
frequency and span will be set as defined in signal standard.
·[Channel]:
press [Freq]→[Channel], to pop up the channel number dialog
box and set the channel number by using number key or [↑]or [↓]key and
spinning wheel.
·[Special Notice]: the channel number shall be set after the signal
standard has been loaded. Otherwise the message of failure to set
will be given.
