67
Tel: 886.909 602 109 Email: [email protected]
10.
Software Toolkit
10.1.
Software Description
The software toolkit of S3101 Cable & Antenna Feeder Tester is mainly applied to control S3101A/B through computer, and realize
reading, saving and comparing of the curve. All of those are convenient for operators to analyze the remote data, and for analyzers to
monitor and maintain system effectively on PC.
Software toolkit mainly provides the following functions:
Recall the curve, open the curve data files stored in PC or within the instrument, which are displayed as graphs;
Collect the curves, gather the sweeping curves of S3101 in real time;
Save the current acquisition curve to the PC;
Curve comparison and operation;
Set the parameters, such as frequency, sweeping points, measuring format, DTF parameters, etc.
Requirements on system configuration of the computer:
Processor of Inter Pentium 4 or higher
Operating system of Windows
Memory of 512 Mbytes
Hard-disk space of 500Mbytes
USB or LAN interface
10.2.
Instructions for Use
10.2.1.
Communication Connection
Connect the device to computer with USB or network cables, and select the communication mode once the software is started. Click the
【
Remote Ctrl
】
key as shown in Figure 10-1, and then select the
【
USB
】
or
【
LAN
】
check box in the
【
Communication
】
group. If
the
【
LAN
】
network communication is selected, it needs IP address of the specified equipment, with the method: click the
【
IP
】
key to pop
up an IP dialog box as shown in Figure 10-2, and then input IP address of instrument, press the “OK” key to complete input of the
specified IP.
Figure 10-1
【
COMMUNICATION INTERFACE
】
Group
