63
Tel: 886.909 602 109 Email: [email protected]
Figure 6-15 Combination Key
b) You may switch the menu circled by red frame with
【
↑
】【
↓
】
keys and locate it to [Config] menu. Press
【
Enter
】
key and
enter setting menu bar;
c) Circle the red frame to [Touch Screen Cal] menu according to similar operation in Step 2. Press
【
Enter
】
key to bring up
calibration page of touch screen.
You may click “+” with sharp pen needle in turn in calibration page. Perform Touch Screen Calibration according to notice on screen.
Press
【
Enter
】
key after completing calibration of 5 points. Then calibration is completed. As shown in Figure 9-16:
Figure 9-16 Screen Calibration
9.7.4.
Software Update
Internal application software of Analyzer is latest corresponding process when delivered. The software might be upgraded in the future
development and maintenance. You may choose to upgrade some software according to your needs. Please contact us in advance if
process update is needed. If you already have an upgrade package, you may place it under root directory of external USB memory or SD
card, or insert it into external memory (thumb drive etc.) Click [Software Update] menu. Applications software will automatically look up
and install upgrade process. Software Update steps are as follows:
1) Press
【
System/Local
】
key and enter system menu bar;
2) Click [Config] menu and enter setting menu bar;
3) Click [Update] menu; Analyzer will automatically look up and upgrade software package. Click OK in turn in the following two dialog
boxes in Figure 6-17 after upgrade software package is found. Wait until new processes are automatically installed. Reboot the
instrument and run new processes after installation is completed.
9.7.5.
Management
Management function of Analyzer provides interfaces for application process, function debugging, and signal passageway indicators
checking. They are not open to operators. Therefore, we encrypt to [Manage] menu to prevent unnecessary system errors occurred by
misoperation of operators. No more tautology here.
9.8.
Self-test
Analyzer will perform testing over each functional component by running a series of testing processes to make sure the instrument runs
