60
Tel: 886.909 602 109 Email: [email protected]
9.7.
Setup
9.7.1.
Date & Time
S3101 Cable & Antenna Analyzer provides system time setting function. System time setting steps of Analyzer are as follows:
1) Press
【
System/Local
】
key and enter system menu bar;
2) Click [Config] menu and enter setup menu bar;
3) Click [Date & Time] menu to bring up a dialog box of “Set Date and Time”. You may edit it with [Prev], [Next], knobs or selecting the
content to be edited by clicking directly. Input modified value via keypad,
【
↑
】【
↓
】
keys, or numeric keys. Click “OK” key on dialog
box or press
【
Enter
】
to complete date and time setting. As shown in Figure 9-11:
Figure 9 -11 Date and Time Setting
In addition, you may also switch display method of date by clicking [Date Format] menu in “Date and Time” menu bar.
9.7.2.
LAN
Similar to common PC system, you may need to reconfigure network of Analyzer system when using computer to interconnect instrument
or performing distance control with tool software in Chapter 7 in order to maintain mainframe computer and Analyzer in the same network
segment. LAN setting steps are as follows:
1) Press
【
System/Local
】
key and enter system menu bar;
2) Click [Config] menu and enter setting menu bar;
3) Click [LAN] menu to bring up “network configuration” dialog box on the screen;
4) Click [IP] menu on menu bar and switch cursor to IP address configuration column and input IP address of each segment with
numeric keys. You may switch to each segment via [Next] and [Prev]. As shown in Figure 9-12:
