56
Tel: 886.909 602 109 Email: [email protected]
Figure 9-3 Label Editing
4) Press
【
Enter
】
key or “OK” key on dialog box. After editing tip, measurement mode name of plot area will display label being edited
by operators.
9.4.
Power Saving Mode
Considering LCD screen service life and power saving principle, S3101 Cable & Antenna Analyzer provides two power-saving modes,
sleep mode and shutdown mode. You may select appropriate power saving mode according to self-test outcome. So-called sleep mode
refers to a status, which will be automatically set by system according to time period set by operators if long time no operation occurred.
In sleep mode, instrument screen will be off, while system is still on. The time period set by operators is sleep time. Sleep time setting
steps are as follows:
1) Press
【
System/Local
】
key and enter system menu bar;
2) Click [Power Saver] menu and enter power saving mode menu bar;
3) Click power saving mode menu bar [Sleep] and set system sleep time with
【
↑
】
【
↓
】
keys, knobs, and numeric keys. Press
【
Enter
】
key and complete sleep time setting. 30s before system enters sleep mode, a “Notice” dialog box will be brought up and indicate
system will enter sleep mode soon, as shown in Figure 6-4. You may click anywhere on screen or any keys (excluding On/Off key
and Reset key) on keyboard to cancel this sleep when the instrument is in sleep mode or countdown to sleep mode. System will
then perform timing operation of the next round according to sleep time. You may also click [Sleep] menu again and turn off
sleeping.
Figure 9-4 System Sleeping Function
Shutdown refers to shutdown of Analyzer in according to time period set by operators. Shutdown setting steps are as follows:
1) Press
【
System/Local
】
key and enter system menu bar;
2) Click [Power Saver] menu and enter power saving mode menu bar;
3) Click power saving mode menu bar [Shutdown] and set system shutdown time with
【
↑
】
【
↓
】
keys, knobs and numeric keys. Press
【
Enter
】
key and complete shutdown time setting. 10 minutes before system shutdown, a “Notice” dialog box will be brought up
and inform shutdown soon. You may cancel automatic shutdown by clicking anywhere on screen or using any keys on keyboard
(excluding On/Off key and Reset key).
