54
Tel: 886.909 602 109 Email: [email protected]
9.
System Management
9.1.
Introduction
This chapter mainly introduces system management operation of S3101 Cable & Antenna Analyzer including functions such as
measurement mode selection, power saving mode selection, self-test, display and system language etc. System setting operation has no
direct relation with testing process, method or result. It mainly performs self-test of instrument, power saving or screen setting under
different circumstances for better observation. One by one introduction on system function is as follows.
Display interface of Analyzer is as shown in Figure 9-1 when tool software introduced in Chapter 10 are used to perform distance control
over Analyzer. A “Remote” control notice is called up next to power notice, while Analyzer does not respond to keyboard keys any more.
You may press
【
System/Local
】
key to switch instrument system to “Local” status if you want to operate via keyboard.
Figure 9-1 Equipment Remote Control TEST
9.2.
Measurement Mode
S3101 Cable & Antenna Analyzer supports two measurement modes, cable & antenna test and power meter test. You may select testing
mode according to your needs. Measurement mode selection steps are as follows:
1) Press
【
System/Local
】
key and enter system menu bar;
2) Click [Measure Mode] menu to call up a “Measure model” selection dialog box;
3) Select measurement mode needed with
【
↑
】 【
↓
】
keys or knobs or by clicking on touch screen directly. Click “OK” key on dialog
box or press
【
Enter
】
and complete measurement mode selection. As shown in the following figure:
