53
Tel: 886.909 602 109 Email: [email protected]
8.6.
Document Management
Document management function is used to transfer, delete, or archive stored testing data, documents or images. Corresponding
operation steps are as follows:
1) Press
【
Save/Recall
】】
key and enter Save/Recall menu bar.
2) Click [File Mgmnt] menu item to bring up a dialog box of document management, menu bar will enter “File Mgmnt” menu, as shown
in Figure 5-8.
3) Click [Source File] menu item to activate the left part of dialog box and press
【
↑
】
【
↓
】
keys or use knobs to select source documents
or folders; or directly select documents or folders to be copied in the left side via touch screen.
4) Click [Destination] menu item to activate the right side of dialog box and press
【
↑
】【
↓
】
keys or use knobs to select destination
path; or directly click file paths where copied documents or folders located on the right side of touch screen.
5) Click [Start Copy] menu item to copy documents. Successful copy message brought out indicates completion of copy.
6) Click [Delete Source File] menu bar to delete source documents. Successful deletion message brought out indicates completion of
delete operation.
Figure 8-8 Document Management Dialog Box
8.7.
Default State
Default state is also original status after each startup of Analyzer. It is advised to use [Default state ] menu to restore initial status if you
want to restore to initial status after completing plenty of parameters setting as it will be comparatively simpler than resetting through
parameters. You may also use
【
RESET
】
to perform this function, however, it is not recommended for too much time taken.
