EN |
15
AMBERAIR COMPACT RH v2019.08
The protective film is intended to protect the unit during transportation. It is recommended to remove the film because oxida
-
tion signs may occur.
The products shall be installed on the legs. In order to do so, the unit should be slightly lifted. The hoisting methods are shown in the section
“Transportation and Storage”.
Note. Before conecting sections, please, remove transportation rubber tapes from rotor wheel,
Extended rotor section connection
5.5.1. PLACE REQUIREMENTS FOR THE EQUIPMENT AND MOUNTING POSITIONS
1. The installation position only in the horizontal direction.
2. Install the supporting legs.
3. AmberAir Compact are assembled from separate sections.
4. They must be adjusted without a gradient.
5.
Leave space in the front (1,5xL) that it would be sufficient to open the doors and to remove or install a required component.
