Sakai SV414, Shop Manual

Page: 44 / 294

3-006
ENGINE AND CONTROLS
4-1-1. Installation of pump
When the pump has been removed from the engine for
repair or replacement, reinstall it in accordance with the
following procedure.
①
Apply adequate amount of grease to pump (8) and hub (4)
splines.
②
Install retaining ring (3) of hub (4) to pump (8) and set to
the specified dimension.
Specified dimension a: 9 mm (0.35 in.)
③
Secure hub (4) with bolts (9).
N•m
(9) Bolt M12×35 : 86 N·m (63 lbf·ft)
④
Secure flange (5) to engine flywheel with eight bolts (2).
N•m
(2) Bolt M10×35 : 49 N·m (36 lbf·ft)
(NOTICE)
Check for direction of flange (5).
Bolt (2) is treated with thread-locking fluid. Use new
thread-locking fluid treated bolt for installation.
⑤
Secure housing (6) to flywheel housing with twelve bolts
(1).
N•m
(1) Bolt M10×25 : 59 N·m (44 lbf·ft)
(NOTICE)
Bolt (1) is treated with thread-locking fluid. Use new
thread-locking fluid treated bolt for installation.
⑥
Engage hub (4) with flange (5).
⑦
Secure pump (8) to housing (6) with four bolts (7), spring
washers and washers.
N•m
(7) Bolt M14×45 : 167 N·m (123 lbf·ft)
•
★
•
•
•
SV414-03002
1
2
3
4
5
7 8 6
A
A
a
SECTION A-A
9