Sakai SV414, Shop Manual, Page: 267 / 294

9-052
TROUBLESHOOTING
2-5-3. Vibration mode cannot be switched (F-R lever vibration switch does not work)
Vibration mode change switch must be “ ” (manual mode).
Vibration select switch must not be “ ”.
Reference Fig.: 2-5-1
Check point Check/Cause Action
1. F-R Lever Vibration
Switch
(1) When starter switch is ON, measure voltage between
F-R lever vibration switch terminal 1 inlet wire RG and
chassis ground.
Standard voltage : 12 V or more
(2) When starter switch is ON and F-R lever vibration
switch is pressed once, measure voltage between
F-R lever vibration switch terminal 2 outlet wire Y and
chassis ground.
Standard voltage : 12 V or more
If above item (1) is OK and item (2) is NG, F-R lever
vibration switch is faulty.
•
Replace F-R lever
vibration switch.
2. Vibration Mode Change
Switch
(1) When starter switch is ON, measure voltage between
vibration mode change switch terminal 1 inlet wire RW
and chassis ground.
Standard voltage : 12 V or more
(2) When starter switch is ON, measure voltage between
vibration mode change switch terminal 3 outlet wire RG
and chassis ground.
Standard voltage : 12 V or more
If above item (1) is OK and item (2) is NG, vibration mode
change switch is faulty.
•
Replace vibration mode
change switch.
3. Harness Connecting
Between Terminals
Measure resistance of harness connecting between
terminals.
Standard resistance : 10 Ω or less
If resistance is abnormal, harness is faulty.
•
•
Repair or replace
harness.
•
•