Sakai SV414, Shop Manual

Page: 158 / 294

6-029
VIBRATORY DRUM • REAR AXLE
②
A gap will remain between end of axle shaft (41) and
inside of cover (32).
Tighten four bolts (30) to a torque of 108 N·m (80 lbf·ft).
Give housing (37) two to three turns.
Tighten bolts to a torque of 108 N·m (80 lbf·ft) again.
Repeat this work several times until tightening torque of
bolts no longer fluctuates.
(NOTICE)
Tighten the bolts alternately in diagonal directions.
(NOTICE)
Push in the inner race while rotating the bearing.
Otherwise, even strongly trying to push the inner
race, the bearing rollers will not be pushed up and
therefore bearing will not be seated.
③
Remove bolts (30).
Remove cover (32).
Remove shim.
(NOTICE)
Do not turn the housing (37) after the cover is
removed.
•
•
•
•
•
•
•
•
•
SV414-06068
30 37
41
32
Shim
Ga
p
PLA-06001
End of rollers in close
contact with inner race shoulder
Ga
p
Ga
p
(1) Bearing not
seated
(2) Bearing correctly
seated
SV414-06069
30
32
Shim
37