Sakai RS45, Manual

Page: 154 / 156

5-016
RAMMING SYSTEM
3.8. Reassembly of Crank case/Cylinder
Reaasemble the crank case and cylinder in the reverse order in which it was disassembled.
(NOTICE)
• When installing the slider (13), apply thread-locking fl uid on the tap portion. RS45, RS55E only (Page
5-010)
• When installing the M8 nut (14), apply thread-locking fl uid on the threaded portion. RS65, RS75 only
(Page 5-010)
• When installing the inner cylinder (9), apply grease on its outer circumference. (Page 5-010)
• Apply lithium-based grease on the bearing, gear teeth and lip of oil seal when install then. (Page
5-008)
• The mounting bolts (1) are treated with thread-locking fl uid. Replace with new bolts after removed.
(Page 5-008)
N•m
(13) Slider : 78 N·m (58 lbf·ft) RS45, RS55E only (Page 5-010)
(14) M12 Nut : 78 N·m (58 lbf·ft) RS45, RS55E only (Page 5-010)
(20) M8 × 35 Bolt : 31 N·m (23 lbf·ft) RS45, RS55E (Page 5-010)
(19) M8 × 16 Bolt : 31 N·m (23 lbf·ft) RS45, RS55E (Page 5-010)
(20) M10 × 40 Bolt : 49 N·m (36 lbf·ft) RS65, RS75 (Page 5-010)
(19) M10 × 20 Bolt : 49 N·m (36 lbf·ft) RS65, RS75 (Page 5-010)
(3) M8 Nut : 20 N·m (15 lbf·ft) (Page 5-010)
(16) M10 × 30 Bolt : 49 N·m (36 lbf·ft) RS45, RS55E (Page 5-008)
(16) M10 × 40 Bolt : 49 N·m (36 lbf·ft) RS65E, RS75 (Page 5-008)
(18) Drain plug : 20 N·m (15 lbf·ft) (Page 5-010)
(4) Filler plug : 20 N·m (15 lbf·ft) (Page 5-010)