41
Figure 52
2. Replace the Integrated and thermo-hygrometer transmitter batteries once every 1-2 years
18.
Troubleshooting Guide.
Problem
Solution
Wireless remote not reporting in to con-
sole.
There are dashes (--.-) on the display con-
sole.
If any of the sensor communication is lost, dashes (--.-)
will be displayed on the screen. To reacquire the signal,
press and hold the
C
button for 3 seconds,
choose the lost sensor and the remote search icon
will be constantly displayed. Once the signal is reac-
quired, the remote search icon
will turn off, and the
current values will be displayed.
The maximum line of sight communication range is 100
m and 30 m under most conditions. Move the sensor as-
sembly closer to the display console.
If the sensor assembly is too close (less than 1.5m), move
the sensor assembly away from the display console.
Make sure the remote sensor LCD display is working and
the transmitter light is flashing once per 60 seconds.
Install a fresh set of batteries in the remote thermo-
hygrometer. For cold weather environments, install lithi-
um batteries.
Make sure the remote sensors are not transmitting
through solid metal (acts as an RF shield), or earth barrier
(down a hill).
Move the display console around electrical noise generat-
ing devices, such as computers, TVs and other wireless
transmitters or receivers.
Move the remote sensor to a higher location. Move the
remote sensor to a closer location.
Indoor and Outdoor Temperature do not
agree
Allow up to one hour for the sensors to stabilize due to
signal filtering. The indoor and outdoor temperature sen-
sors should agree within 2 °C (the sensor accuracy is ±
1 °C).
Use the calibration feature to match the indoor and out-
door temperature to a known source.