SAIC MG 6, Service Manual

Page: 320 / 357

Maintenance
Bonnet
Opening the Bonnet
DO NOT drive when the bonnet is retained
only by the safety catch.
A
B
1 Pull the bonnet release handle (A) from the inside
of the car.
2 Push the lever (B) mounted on the bonnet upward to
release the bonnet safety catch.
3 Raise the bonnet and release the lever.
Closing the Bonnet
Support the bonnet with two hands and lower down
the bonnet until the distance between it and the locking
platform is approximately 30
－
40 cm, then push with a
downward force to fully close the bonnet.
By attempting to lift the front edge of the bonnet, check if
the lock is fully engaged after closing the bonnet. If it is not
fully engaged, you must repeat the operation.
Warning When the Bonnet is Open
If the bonnet is not fully engaged, a warning will be displayed
in the message centre when the ignition is in Position
Ⅱ
(see Message Center in Instruments and Controls chapter)
. There will be warning sound if the bonnet is not fully
locked while driving. And the icon will flicker also.
302