Maintenance
Bonnet
Opening the Bonnet
DO NOT drive when the bonnet is open or
retained only by the safety catch.
A
B
1 Pull the bonnet release handle (A) from the inside
of the car.
2 Push the lever (B) mounted on the bonnet in the
arrow direction to release the bonnet safety catch.
3 Raise the bonnet to open it.
Closing the Bonnet
Hold the bonnet using both hands and lower it, allowing it
to drop for the last 20
～
30 cm to fully close the bonnet.
By attempting to lift the front edge of the bonnet, check
if the lock is fully engaged after closing the bonnet. If it is
not fully engaged, please reopen the bonnet and repeat the
closing action.
Bonnet Open Alarm
If the bonnet is not fully engaged, when the ignition switch
is located in ON/RUN/START position, the corresponding
alarm icon (refer to "Message Centre" in "Instruments and
Controls" chapter) will be shown on the message centre
display. If it is detected that the bonnet is not fully engaged
while driving, an audible warning will sound.
263
6
Summary of Contents for MG HS
Page 88: ......
Page 166: ...Seats Restraints normally for those about 7 years old or those older than 7 years old 152...
Page 269: ...Emergency Information Code Specs Function F53 F54 255 5...
Page 272: ......
