MXS System Description and Installation Manual
UM06945
© Sagetech Avionics 2022 Proprietary Confidential
Page 33 of 56
7.0
Power up Process
In the following steps an example power up process is shown using a Sagetech provided GUI. The Sagetech
MXS GUI communicates with the Sagetech defined protocol as specified in the ICD02373. This GUI
simulates a GPS Position for the purpose of testing transponder functionality, but it should not be used to
send position information to the transponder in flight. For detailed procedures using the MXS Com Test
GUI refer to UM06951.
7.1
Setup Equipment
Configure and connect the system as shown in the following sections of this document:
•
3.1: For block diagram of system.
•
4.0: For installation instructions.
•
6.0: For wiring the host and transponder
7.2
Power Up The MXS
Connect the MXS to the “MXCom
-
MXSTool” GUI as shown below. Defaul
t Baud rate is programmed to
230.4kbaud but the bootloader message always outputs at 38.4kbaud.
Figure 7-1 MXS Com Test GUI
