3-65
Using the Operator Panel
Sleep Timer Timeout Time
You can adjust the length of time the printer waits before entering Auto Sleep in the
absence of data. The default time is 15 minutes.
The printer reverts to normal operation mode when the printer receives a print job,
the operator panel is operated, or one of the exterior covers is opened.
Press
[MENU]
.
Press
or
until
Others >
appears.
Press
.
Press
or
repeatedly until
>Sleep Timer >
appears.
To change the timeout time, press
[OK]
. A blinking cursor (_) appears.
Press
or
to increase or decrease the value at the blinking cursor and set
the desired time. The timer can be set between 5 and 240 min, in 5- minute
increments. Use
and
to move the cursor right and left.
When the desired timeout time is displayed, press
[OK]
.
To exit the menu selection, press
[MENU]
.
Received Data Dump
You can print data received by the printer as hexadecimal code for debugging
programs and files.
Press
[MENU]
.
Press
or
repeatedly until
Others >
appears.
Press
.
Press
or
repeatedly until
>Print HEX-DUMP
appears.
Press
[OK]
. A question mark (?) appears.
Press
[OK]
again. The message
Processing
appears for a second, followed
by Waiting.
While the message display is indicating Waiting (for 30 seconds by default),
send data to be hex-dumped to the printer. The message display indicates
Processing while the data is being received.
You can cancel printing of any more dump data by pressing
[GO]
, and
then
[CANCEL]
.
Once all data has been received, the message
Waiting
will appear.
Press
[GO]
to finish hex-dump printing.
LU 252 745 005 Fonctions d'impression HFF GB.book Page 65 Mercredi, 7. juin 2006 4:56 16
