67
Unless stated otherwise, all dimensions are given in mm.
MANTO®
5.3 With the PM Aligning Wedge Clamp
Use the PM Aligning Wedge Clamp (code:606900) to connect MANTO Panels and align
them flush without offset.
If the PM Aligning Wedge Clamp is not attached to the panel joint, e.g. when the
formwork is being moved, it can be fastened in the Aligning Wedge Clamp Holder
(code:606970) to store it. Then it is readily available for the next use.
The PM Aligning Wedge Clamp and the Aligning Wedge Clamp Holder together make
up the Panel Connection Unit. The PM Aligning Wedge Clamp can also be purchased
separately.
5.3.1 Attaching Panel Connection Unit to MANTO panel
The mounting positions of the Panel Connection Unit are shown in the following illustra-
tions. Attaching the Panel Connection Unit in these positions ensures that the PM Align-
ing Wedge Clamp can always be mounted in a suitable position. We recommend adher-
ing to these mounting positions.
The Panel Connection Unit cannot be attached to panels that are not shown in the fol-
lowing illustrations. However, the panels can still be connected using the PM Aligning
Wedge Clamps available separately.
MANTO G2/G3 Panels 240
240/330
240/270
240/120
240/90
240/60
MANTO G2/G3 Panels 120 and 105
120/330
120/270
120/120
105/330
105/270
105/120
Summary of Contents for Huennebeck MANTO G3
Page 1: ...MANTO Large frame panel formwork User guide...
Page 9: ...9 Unless stated otherwise all dimensions are given in mm MANTO...
Page 61: ...61 Unless stated otherwise all dimensions are given in mm MANTO MANTO G3 M MANTO G3 M...
Page 219: ...219 Unless stated otherwise all dimensions are given in mm MANTO...
