SAFWAY Huennebeck MANTO G3, User Manual, Page: 139 / 224

139
Unless stated otherwise, all dimensions are given in mm.
MANTO®
12.2 Using the PLATINUM 100 Bulkhead Clamp
From 100 mm to 425 mm wall thickness
Stop-ends for wall thicknesses ranging from 100 mm to 425 mm can be formed with the
PLATINUM 100 Bulkhead Clamps. The Bulkhead Clamps support the stop-end form-
work and also act as tension-resistant dry ties. They can be attached at any height to
MANTO panels assemblies either upright or lying on the ground. The nail holes in the
PLATINUM 100 Bulkhead Clamps make it easy to secure the timber stopend formwork.
Nail holes
N
V
Wing nut, for simple
hand or hammer op-
eration, or use with
the MANTO Ratchet
(code:408780).
M
Panel rib
PLATINUM 100
Bulkhead Clamp
(code:604328)
Stopend (built on
site).
V
Safe Working Load of the PLATINUM 100 Bulkhead Clamp (code:604328)
Tensile (N): 36.00 kN
Shear (V): 36.00 kN
Bending (M): 5.00 kNm
Be aware that some sections are subjected to higher tensile loads (Refer to the table
below)!
The following table shows the quantity of Bulkhead Clamps needed at the stopends
and the connectors needed in the section 1, which is subjected to a higher tensile load.
Stopend
MANTO panel
(Height)
Wall thickness ≤ 300 mm Wall thickness 300 mm - 425 mm
Stopend Area 1 < 500 mm Stopend Area 1 < 850 mm
No. of stop-end hold-
ers*
No. of Aligning Panel
Clamps
No. of stop-end hold-
ers*
No. of Aligning Panel
Clamps
2.70 m 3 2 3 2
3.30 m 3 2 3 2
2.70 m / 1.20 m 3/1 2/1 3/1 2/2
3.30 m / 1.20 m 4/1 2/2 4/1 3/2
2.70 m / 2.70 m 3/3 3/2 3/3 3/3
2.70 m / 3.30 m 3/4 3/2 3/4 3/3
3.30 m / 3.30 m 4/4 3/2 4/4 3/3