Make sure the device run and connect to the Sigfox Network successfully;
1.5.3.2 Installing the device at the actual location as below steps:
Locate the place to detect the target gas. Please follow
;
Make sure the site is good enough for RF signal transmission. Please take notes as in
;
Mount the sensor onto a wall by two screws as
Problems with Sigfox communication like not receiving the packets...please refer to
to troubleshoot
the device.
Problems with the sensor functions like not measuring or inaccurate measuring....please refer to
to
troubleshoot the sensor part.
Maintenance works
Yes/No
Descriptions
Consumable parts replacement
Yes
The battery is the only part need to check the
lifetime to replace. Check the battery status on
the back-end system.
Cleaning device
No
.
The Daviteq Sigfox-Ready GHC Flammable Gas Sensor comprises 02 parts connected together:
- The Daviteq Sigfox-Ready wireless transmitter
- The Daviteq GHC flammable sensor module
ATTENTION: REVERSED POLARITY OF BATTERIES IN 10 SECONDS CAN DAMAGE THE SENSOR
CIRCUIT!!!
Note: DO NOT OPEN THE DEVICE OR REPLACING BATTERY DURING INSTALLATION AT SITE
(HAZARDOUS AREA ZONE 0, 1, 2)
2. Maintenance
2.1 Troubleshooting
2.2 Device maintenance
2.2.1 Maintenance for Wireless transmitter
2.2.2 Maintenance for GHC sensor module
3. Advanced Guide
3.1 Operating principle of the Sigfox-Ready GHC Flammable Gas
Sensor
3.1.1 Operating principle of the complete device