USER MANUAL
EvaluationTools
STIM300 STIM377H Evaluation Kit
DOK453 rev.2
Page 5 of 29
1.2
Configurable and readable parameters
Configurable parameters in Service Mode and Utility Mode:
Output format (angular rate, increment angle etc.)
Datagram format
Sampling rate
Bias Trim Offset
Bandwidth/ Low pass filter frequency
RS422 transmission bit rate
Number of stop bits in datagram
Parity
Line/ Datagram termination
Readable parameters:
Part number
Serial number
Firmware revision
Hardware revision
Gyro module diagnostics
Detailed diagnostic information includes RAM and flash checks, stack handling checks, status of internal voltage
supply references, and various parameter reports for each measurement axis are available from the supported
SERVICE mode.
Note
: Time of Validity (TOV) and external trigger functionalities of STIM300/STIM377H are not supported by the EVK
PC-software.
2
Kit contents
PCIe kit:
o
PCIe to RS422 interface card
o
STIM300/STIM377H communication and power cable
USB kit:
o
USB to RS422 interface cable with USB power supply connector
Memory stick with:
o
PC software
o
User manual for evaluation kit
Tool for fixing connector of communication and power cable to the gyro module
Note that the evaluation kit does not include a STIM300/STIM377H IMU module. This must be ordered separately.
3
System requirements
Windows XP SP2 (or later), Windows Vista, Windows 7 (32/ 64bit) , Windows 10 (32/ 64bit)
PCIe kit:
o
1 free USB port and 1 free PCIe slot
USB kit:
o
2 free USB ports
Quad core processor recommended (when simultaneously logging data from two gyro modules)
