MorphoAccess® SIGMA Series - Administrator Guide
Threat Level Configurations
2017_2000025464-v03
This document and the information therein are the property of Morpho. They must not
be copied or communicated to a third party without the prior authorization of Morpho
406
July 17
Threat Level Configuration
This feature allows an administrator to set threat levels using the TTL input lines. When enabled,
the TTL signals can define the level of security and also can be used to compel users to use a
specific authentication method. The available choices are Card Only and Card + Biometrics. For
example, if Threat level 1 is set to Card + Biometrics and the TTL input for GPI0 is triggered, a
successful verification requires presenting a smart card and a finger to the terminal.
If TTL is not active (both lines are 0), the verification follows command based inputs.
Besides Webserver, these configurations are possible via MorphoBioToolbox and distant
commands also.
Threat Level Configuration through Webserver
Access Path
Webserver > Terminal Settings > Threat Level
Screens & Steps
Figure 337:
Configuring TTL Based Threat Level
1.
Select Threat Level Mode as “TTL based”. In this mode, Active Threat Level will be
determined by the current TTL line status and its mapping as per GPI to Threat Level
Mapping. For example, to activate Threat Level 2, GPI1 line should be triggered. GPI
to Threat Level Mapping allows an administrator to configure active threat level as per
the GPI line.