MorphoAccess® SIGMA Series - Administrator Guide
Access Control by Authentication
2017_2000025464-v03
This document and the information therein are the property of Morpho. They must not
be copied or communicated to a third party without the prior authorization of Morpho
376
July 17
Activation key
The administrator must select a Card Type that can accommodate User ID.
The Trigger event corresponding to ‘Card’ must be set to ON
The administrator needs to configure the User Record Reference parameter value to
Card for authentication using terminal database, by using Terminal Menu or Webserver.
Please refer to “
” (Step: 37).
User interface
The authentication process starts when the user presents his contactless card in front of the
terminal (where the antenna of the contactless card reader is located). If the user’s identifier
read on the card is found on the terminal’s internal database, then the user will be asked to
place his finger on the biometric sensor, for biometric authentication.
Figure 329:
Authentication with biometric check, reference in database
The terminal then compares the biometric data of the finger on the sensor with the reference
biometric data found in the terminal database.
The authentication process is successful (identity confirmed), if the captured finger data
matches with one of the two reference finger data. Authentication fails, if the captured finger
data does not match the corresponding one in the terminal database.
The result of the authentication process is notified to the user by an audio signal, as described
in “Terminal States” section.
The terminal reverts to its initial state, when the authentication process is completed,
irrespective of its outcome. This implies that the terminal will now look for a card detection.
When no users have been enrolled in the database, the authentication process is disabled. Users
are not allowed access in this mode. The terminal notifies this invalid state to the user, as
described in “Terminal States” section.
Database