M2050 Recovery System
User Instruction Manual
I
NSTRUCTION
# IM-0017 REVB
I
SSUE
D
ATE
10/28/10
E
XPIRATION
D
ATE
10/28/20
4451 Raceway Dr • Concord, NC 28027 • Customer Service Phone (800) 560-1094 • Fax (800) 560-1275
Page 6 of 7
Storage and Maintenance Log for M2050 Recovery System
A written log of all servicing and inspection dates for this device should be maintained by the company safety officer.
1. Always dismount the devices from the Tripod. Store the Tripod in Transport mode in an area free of corrosive elements and
excessive heat.
2. Do NOT store this unit in environments corrosive to aluminum. Additionally, avoid use in areas that may contain high
concentrations of ammonia. Avoid use with acids, alkaloids, or other caustic chemicals especially at elevated temperatures.
3. Clean exterior of case with water and mild soap detergent, rinse, and thoroughly air dry. Do NOT use harsh chemicals.
Clean labels as required.
4. Never attempt to lubricate, adjust, repair, or modify any part or component.
5. Repairs MUST be performed by SafeWaze.
6. Return unit, properly packaged, with contact information to:
SafeWaze
4451 Raceway Drive
Concord, NC 28027
WARNINGS
Employer must instruct employee as to proper use and warnings before use of this equipment.
Read, understand, and follow all instructions and warnings provided with this unit.
For use by properly trained personnel only.
Always use the buddy system (two workers) while operating.
Insure that the Tripod is positioned on a hard, stable surface before use.
To insure compatibility, use only SafeWaze® components.
Do NOT use the Personnel and Material winch at the same time. Use only one device per pulley assembly per eyebolt.
Inspect before each use. If any part or component shows damage or excessive wear, or does not function properly, the entire unit should be
removed from service.
Never use any occupational protective equipment for anything other than its intended use.
All occupational protective equipment must be inspected and thoroughly tested before each use.
Do NOT use this unit if the total workload exceeds 310 lbs.
Inspection Procedures
WARNING:
Never use the M2050 Recovery System without prior inspection
1. Inspect the work area for debris and other material that could cause injuries or interfere with the operation of the unit. Be
sure that the Tripod is positioned on stable, hard ground before setting it up.
2. The leg chain and all locking pins must again be checked to see they are correctly securing equipment. Never use the
Tripod without the chain.
3. A competent person, for example a safety director, must schedule regular safety inspections based on amount for use and
working conditions.
4. Remove from service immediately if any function, component or part does not pass this inspection, or whenever subjected to
a fall arrest.
5. Never use the Tripod in conjunction with safety devices not manufactured by SAFEWAZE® or designed specifically for use
with this Tripod.