WC180 Flashing Door Chime Kit
Instruction Manual
Sold by 1800doorbell.com
Instructions for
wireless plug-in
chime kit
(
Model no.WWB035A)
1. Use a small screwdriver to open the cover of transmitter. Insert the supplied 1pc 3V CR2032 button cell with
positive (+) up, observe polarity.
2. Locate a good position for the pushbutton next to the door. Do not mount on or next to a metal surface. Drill
two 4.76mm holes and insert the wall plugs. Place the back plate in the right position and tighten the plate
on wall with the screws (2.6 x 26mm BA type) supplied. Close the cover.
*if you are mounting the pushbutton on a metal or stucco surface,it is recommended you place a wood or cardboard shim
under the pushbutton. This helps the radio signal eminate from the button more easily.
3. Plug the receiver into a 120V AC mains two flat pin socket.
4. Press “Learn” button ( symbol
) once at the side of receiver, the receiver will sound 2 beeps. It
indicates the receiver is in learn mode process.
5. Press the transmitter once, and you will hear the chime receiver sound. This indicates the receiver is
learning the signal from transmitter properly. Press the transmitter to hear the built-in tunes in the receiver.
Stop pressing the transmitter when you hear the desire melody. There are total 3 different chime tunes for
selection.
-
ding ding
-
ding dong
-
Westminster 4-note chime
6. After that, press again “learn” button on the receiver, the receiver will sound 2 beeps to exit the learn mode
Or, just wait approx. 20secs, the receiver will exit the learn mode automatically.
7. Press the transmitter, the receiver will sound the tune selected, and then flash.
8. Receiver can learn up to 4pcs of transmitter. Repeat the above step.4, 5, 6, 7.
9. Locate the chime receiver within the working range 125ft.
10. It is possible to erase all learned transmitters. Press & hold the “learn” button on the receiver approx. 15secs
until it sounds 4 beeps. It indicates all learned transmitters have been erased successfully.
11. Factory will link up the transmitter & receiver and pre-set the melody to “ding ding” before shipment.
Notes:
The radio signal’s strength depends on constructional conditions when being transmitted through walls,
paneling, furniture and other obstacles- walls, in particular reinforced concrete walls and ceilings lead to a
reduction in range.
SafeGuard Supply, LLC.
2260 Moon Station Ct. NW
STE 110
Kennesaw, GA 30144
