MAX100/200-OPERATION Rev200813
9
5. DISPLAYS AND CONTROLS—ACCUMAX
Fury, Fusion and APEX Displays
Color-Coded Rain Guard
Fury, Fusion, and APEX displays shall be equipped with color-coded removable rain guard at the top of each display.
The rain guard deflects water and dirt from running down the display. The colors shall comply to NFPA #1901 discharge line
colors. The discharge display color shall match the discharge color (installer responsibility).
Displays: FURY, FUSION, APEX
High brightness LCD screen shall have numerical, alpha, and graphical displays for discharge and foam system operations.
Each display (FURY, FUSION, and APEX) are unique, with various selectable buttons, menus, and functional operations.
System messages and errors are shown through indicators on the display. See further details of the screen elements in the
Operation manual. See further details of the screen elements in the later Sections in the Installation Manual #1 and Operation/
Service/Parts Manual #2.
Foam Delivery ON/OFF Button
The RED button turns foam delivery to the manifold or discharges:
ON
or
OFF
. To turn ON or OFF, press and hold
this button for two seconds. When foam delivery is ON, the foam concentrate will be delivered at a specified rate as soon
as water flow from the discharge is detected.
Up/Down Buttons
The
YELLOW
buttons with
UP/DOWN
arrows control the foam proportioning rate adjustment either incrementally
higher or lower.
a. When pressed once: a lower (
DOWN
) and higher (
UP
) preset for foam proportioning rate will be recalled (if it exists).
b.
For fine adjustment of foam proportioning rate: press and hold either the
UP/DOWN
button. The rate will start to adjust
up/down by 0.1% steps; release this button to stop the adjustment.
c. NOTE
: a temporary preset at the current value will be added when the button is released. Presets can be changed, added
or deleted by using
USER SETTINGS
from the main
MENU
button.
Select button
When the
BLUE
‘SELECT’ button is
pushed
, it changes the data displayed on selectable display located on the bottom
of display screen. The button allows operator to read out values for various system parameters as needed. Additionally, it will
also allow operator to access "
Water Flow Simulation Mode
". The parameters listed below are selectable with this button
can be customized to operator’s need using USER SETTINGS from the
MENU
button.
• Foam Total Volume
*
• Foam Flow System
• Foam Total Volume System
• Foam Tank Level [1]
• Foam Tank Time to Empty* [1]
• Foam Manifold Pressure
• Water Pressure [2]
• Water Flow *
• Water Total Volume*
• Water Total Volume System
• Water Simulated Flow **
NOTE 1: * enabled to be displayed by default
NOTE 2: ** always enabled
NOTE 3: [1] - for systems equipped with TankVision Foam Tank Gauge
NOTE 4: [2] - Fusion (MAX200 Model Only)
List of Available Parameters that can be Selected: