53
•
From the side walls of the stove:
at least 30 cm
•
From the rear: rear connection
at least 20 cm
•
From the rear: top connection
at least 20 cm
•
Within the radiation range of the glass:
at least 80 cm
•
Floor protection in front of the appliance:
at least 50 cm
•
Floor protection at the sides:
at least 30 cm
In order to be able to install the stove levelly, adjustable feed have been foreseen. Adjust these when
necessary so the stove is positioned as flat as possible.
7. Connection of the stove to the chimney
The stove can be connected directly to the chimney (outlet at the back). The diameter of the outlet duct
must correspond with the 150mm diameter of the stove’s outlet connector.
If the draught of the chimney is too strong (> 20/22 Pa), a draught regulator must be built in.
You must also take the following into account with regard to the diameter of the outlet duct:
•
The diameter of the outlet duct may not be reduced. In addition, the outlet duct must fit perfectly onto the
chimney.
•
The stove duct may not be smaller than the diameter of the chimney, since this will hamper the upward
pressure of the fumes. In order to prevent this, you should provide a double wall lining.
Summary of Contents for ePure
Page 15: ...15 ...
Page 30: ...30 13 Pièces de rechange Vous pouvez obtenir des pièces de rechange auprès de votre revendeur ...
Page 45: ...45 ...
Page 60: ...60 ...