6. Replacing the lamp tubes
Distance
35cm
25cm
15cm
Duration of light therapy
Approx. 2 hours
Approx. 70 minutes
Approx. 30 minutes
1. Switching on the appliance:
2. Taking the light
Now sit down in front of the light or as close to it as comfortable, between 15 cm and 35 cm. You can go
about your normal activities while using it. You can read, write, make telephone calls, etc. When using the
appliance, try to maintain the recommended distance of 15 - 35 cm between your face and the appliance.
In effect, the closer you are to the source of light, the less time you need to use it.
Note:
• Do not look directly into the light continuously! Some eye pain or mild headaches may be experienced during initial
sessions but these should pass. If in doubt just lower your treatment times until comfortable again.
• Do not leave the appliance unattended
• Do not touch the appliance in the duration. Let the appliance cool down before reposition it.
• To ensure the product services life, you can use the appliance up to 2 hours, but do not use more than 4 hours in each
use. Let the appliance cool down for at least 15 minutes before reuse.
• Do not block vent holes in the duration.
3. Enjoying light over longer periods
During the darkest period of the year, repeat the treatment for at least 7 consecutive days, or longer, depending
on your individual requirements.
1.
2.
3.
In the event that the light is faulty, or when it comes to end of life, the light tube can be replaced.
Note: Do not replace the lamp tube which is not provided by the supplier. To do so, proceed as follows:
• Always unplug the appliance and let it cool off.
• For safety reasons, do not remove any components or screws other than those specified below.
1. Slacken the retaining screws on the back using a screwdriver, and remove the front cover.
2. Remove the tube transparent retaining clip using a screwdriver.
3. Carefully pull the tube out of the housing and replace a new tube.
4. When inserting the tube, following these instructions in reverse order.
Summary of Contents for DL08128
Page 8: ......
