SAC 3600 Series, Operator'S Manual

Page: 64 / 134

Page # 64
877 1st Ave. N.W. | Sioux Center, IA 51250 | Toll Free: 1.866.722.1488 | siouxautomation.com
OPERATION
REPLACEMENT PARTS
READ complete manual CAREFULLY
BEFORE attempting operation.
877 1st Ave. N.W. | Sioux Center, IA 51250 | Toll Free: 1.866.722.1488 | siouxautomation.com
OPERATION
REPLACEMENT PARTS
READ complete manual CAREFULLY
BEFORE attempting operation.
IMPORTANT! READ BEFORE OPERATING MIXER. IT IS THE RESPONSIBILITY OF
THE OWNER TO MAKE SURE THE MIXER IS SET UP PROPERLY. THE FOLLOWING
RECOMMENDATIONS SHOULD BE HELPFUL
• Safety Decals for readability. If any safety decals are removed, obstructed, or otherwise not understandable, they
should be replaced immediately. Keep all decals clean and visible.
• Safety Shielding to be sure all shielding is in place and functions properly. Replace all damaged or missing shielding
immediately - see parts pages for more information.
• Bolts and Set Screws after a few hours of use and each month thereafter. Tighten if necessary.
• Auger Knives
Should be rotated/replaced when the long stem material is no longer sufficiently broke up, and there is a
noticeable increase in horsepower requirements. Inspect knife fasteners to be sure they are tight. Replace
any damaged or missing hardware.
• Wheel Bolts must be kept properly torqued. Damage to the rim may occur if wheel bolts are not checked frequently.
• Freezing Weather: Snow can accumulate in mixer if stored outside, check hopper for snow or ice buildup before
operating unit. Thaw and remove any obstruction.
IMPORTANT: WHEN WELDING ON THIS UNIT: Do NOT allow the current to flow through the bearings, or scale weigh
bars. Ground directly to the item being welded. ALWAyS disconnect weigh bar cords from scale indicator and the
batteries of the truck before welding.
INSPECT AND ADjuST
• Scale Indicator: Refer to the electronic scale operators manual for adjustment information. The operator’s manual
for the Electronic Scales should be kept with this manual. Additional scale manuals may be obtained through Sioux
Automation Center, Inc.
• Scale Bars: Should be kept clean, dry and lubricated to insure dependability.
• Normal Scale Activity: Some warm up scale “drift” may occur after the scale is turned on but should zero balance within
10-15 minutes. Scale may zero shift over night due to temperature changes.
ELECTRONIC SCALES
INSPECTION AND ADJUSTMENTS