SAC 3600 Series, Operator'S Manual

Page: 31 / 134

Page # 31
877 1st Ave. N.W. | Sioux Center, IA 51250 | Toll Free: 1.866.722.1488 | siouxautomation.com
OPERATION
REPLACEMENT PARTS
READ complete manual CAREFULLY
BEFORE attempting operation.
877 1st Ave. N.W. | Sioux Center, IA 51250 | Toll Free: 1.866.722.1488 | siouxautomation.com
OPERATION
REPLACEMENT PARTS
READ complete manual CAREFULLY
BEFORE attempting operation.
CONTROLS
Page | 12
Figure 17
The switch pad that is located on the armrest controls the rear door, auxiliary function, and turns the conveyor and
augers on and off. Figure 17 shows the location of the controls and which functions they provide. The switch in
the upper left of the switch pad (closest to operator towards engine) turns the discharge conveyor on and off. This
is a momentary on/off switch, so pressing the switch once will turn the conveyor on, and pressing it again will turn
the conveyor off. The switch closest to the operator on the mixer side turns the augers on and off. Like the
conveyor switch, this is also a momentary switch (press once to turn on, once to turn off). The next column of
switches towards the passenger side controls the rear door. By pressing and holding the forward switch (engine
side), the rear door will close. Pressing and holding the rearward switch, the door will open. The third column of
switches control the auxiliary hydraulic function. Like the rear door switch, pressing and holding the forward
switch will move the auxiliary function either out/down, and pressing and holding the rearward switch will cause
the auxiliary function to move either in/up. The fourth column of switches is not used.