EN
Stone, shell
Whats included:
1.
Wrench
2.
Whetstone
3.
Collets (3)
4.
Drill Bits (2)
5.
Diamond Burrs (2)
6.
Aluminium Oxide Grinding Stones (6)
7.
Abrasive Cut-Off Discs (7)
8.
Sanding Discs (8)
9.
Cutting and Sanding Disc Mandrel (1)
10.
Small and Large Sanding Mandrel (1 Each)
11.
Small and Large Sanding Bands (2 Each)
12.
Felt Polshing Mandrel (1)
13.
Felt Polshing Wheels (4)
14.
Accessorie Boxes (3)
Inserting the battery into the machine Ensure that
the exterior of the battery is clean and dry before
connecting to the charger or machine.
•
Insert the battery (2) into the base of the
machine
•
Push the battery further forward until it clicks
into place.
Charging the battery (with the charger)
•
Plug the charger plug into an electrical outlet
and wait for a while. The LED indicator will
lighten up and show the charging status.
LED Charger status
Red
Battery charging in progress
Green Battery charging finished, battery fully charged
•
Fully charging the 1.5Ah battery may take up
to 60 minutes.
•
After the battery is fully charged remove the
charger plug from the outlet and remove the
battery from the charger.
Holding and guiding the tool
Fig. 3
•
For precision work (engraving): pencil grip (A)
•
For rough work (grinding): paring knife hand
grip (B)
•
When you need to keep the tool parallel to the
work surface (e.g. using a cut-off wheel): 2
hand golf grip (C)
4. Accessories for the rotary tool
Grinding stones
Fig. 4
When using a grinding stone the first time, use the
dressing stone to balance it. The dressing stone
can also be used for cleaning the surface or to
give the grinding stone a special shape.
Felt wheels and tip
Fig. 5
The felt wheels or tip should be screwed on the
mandrel.
Material
Speed setting
Steel
+
Sanding bands and disc
Fig. 6
Speed setting
Plastic
-
High speed cutter, Dia
Drill
Fig. 8
Material
mond wheel point and
Speed setting
Stone, shell
Max
Steel
+ -
Aluminium, brass
+ +
Plastic
-
Abrasive disc
Fig. 9
Material
Speed setting
Steel
+
Aluminium, brass
+ -
Plastic
-
Collets:
you can change the size depending
on the width of the shaft of the accessories in
question. So, you would place a 2.3mm Collet
with a 2.3mm accessories.
Material
Wood
+
+
Steel
-
Aluminium, brass
+
-
Material
Speed setting
-
Steel + -
Aluminium, brass + -
Plastic
-
Aluminium, brass
+
-
Plastic
+