Troubleshooting - LED Lights
LED lights do NOT
illuminate when light
switch is pressed ON,
but LED light switch
illuminates.
LED lights do NOT
illuminate when light
switch is pressed ON,
AND LED light switch
does NOT illuminate.
LED lights DO
illuminate when light
switch is pressed ON,
but LED light switch
does NOT illuminate.
Problem (Lights)
Possible Cause
Check Procedure
Prevention/Solution
LED wires disconnected.
Faulty LED light(s).
Transformer lead wires
disconnected (if used).
Switch wire harness
disconnected.
Bad LED light switch.
Check to ensure that wires at
each LED spade terminal are
firmly connected and not loose
behind control panel.
If good connection at LED, and
other LED lights are
operational, then bad LED.
Check that transformer output
connector is engaged and
locked with no loose wires at
the connectors.
Check that the switch wire
harness is connected properly
to back of switch.
Switch wire harness is
attached and LED lights
illuminate.
Reconnect wires at spade connectors on the LED.
If wires will not stay attached and are loose,
contact Saber for warranty replacement parts.
Contact Saber for a warranty replacement part.
Reconnect the transformer wire connectors. If
wires pull loose from the connectors, contact
Saber for warranty replacement parts.
Reconnect switch wire harness to switch ensuring
that harness locks to switch.
Contact Saber for a warranty replacement part.
20
