K-ROTOLIFT RF
24
Setting favorite position and rotation angles
20.
Movement Accuracy:
Please note that, due to many external reasons the accuracy of
rotation might be within the tolerance of
2°-3° for left/right movement and 1°-2° for
central “0” setting. Thus it is recommended taking this into consideration when designing
the furniture and leaving enough free space inside your furniture.
Using the programmed remote control, you can set the maximum ranges of motion:
a. Press & hold
SETUP button
for about 2 seconds
–
red SETUP led
will be lit
b. Press the
DOWN button
to set the position. Press the
DOWN button
again to stop
the lift. If you do not stop the lift with DOWN button, it will automatically stops at the
lowest position when the lower limit switch is reached.
c. Press
RC-SET button (
You will hear intermittent beeper signal) and press the
DOWN button
. You will see this symbol
on the display. The down position has
been set.
NOTE:
Thus setting DOWN VP might be unnecessary. DOWN VP is set to the lowest possible
position by default.
d. Press the
UP button
to set the position. Press the
UP button
again to stop the lift.
If you do not stop the lift with UP button, it will automatically stops at the highest
position when it reaches the up limit switch
e. Press
RC-SET button (
You will hear intermittent beeper signal) and press the
UP
button
. You will see this symbol on the display . The up position has been set.
f.
Use the
assigned buttons
on the remote to rotate the lift to your preferred left /
right position
g. press the
RC-SET button
on the controller or the programmed IR remote control.
You will hear a beep to indicate that the device is waiting for the expected function
to be entered
h. press the button corresponding to LEFT OR RIGHT movement on your RF or IR
remote. For M1 (clockwise) this symbol will appear:
For M2 (counter-clockwise)
this symbol will appear :
NOTE:
You can pick any angle to set those parameters to. For example, you can rotate the lift to
around 30° left and set M1, then move it to 100° left and set M2 position.
i.
After you are done with all the settings, simply leave the SETUP mode by pressing
& holding the
SETUP button
for about 2 seconds, until the red SETUP LED light
will go off. The preferred positions are now set and the controller is in normal
operation mode.
