De-Burr The Side Frames
We recommend de-burring the edges of the carbon parts in areas where electrial wires run. See Page 4.
ESC Installation
The electronic speed control (ESC) is intalled in the front part of the helicopter.
You can easily fasten the ESC with cable ties as shown in figures 1 and 2. Take care of orient the closure of the ties as show in Figure 3.
Figure 4:
You can see the wiring for connecting the ESC to the central unit. Use cable ties to fasten the wires as indicated by the arrows.
Figure 5:
Route the ESC throttle wire as shown, you can use hot glue to keep the wire in place.
Figure 6:
You can install a BEC or Battery if required as shown.
You can install a BEC if required as shown.
Copyright © 2014 - SAB Heli Division - All rights reserved
Page 18
Chapter 10, Installation Of The ESC
