R5
SUPREME - Navigation System
MAINTENANCE
7000 118-383, P11A1
Page 125
To view the contents of a sub folder, mark the folder in the list and press the button
“Open” using the touch interface, or use the arrow keypad and press ENTER. To go
back to the previous folder, use the touch interface or the arrow keypad to press the
“Up” button in upper right corner of the view.
4.
Press “Load” to load configuration from the selected file. A virtual keyboard prompting
for the Sensor password will appear, if set (Enter the password and press ENTER on
the virtual keyboard).
5. A popup will appear stating how many parameters that have been loaded.
Figure 122
– Sensor Config successfully loaded
Alternatively, can the configuration settings be loaded; by the R5 Navigation
Sensor’s web
interface, see section 9.4.1.
12.4 Factory reset
All configuration parameters described in section 10.1 can be set to default values from the
Factory Reset
view which can be accessed from
Main Menu
Maintenance
Factory
reset
.
Input the CDU Password (default=cdupwd) and press the Reset button to reset all
parameters on both CDU and Navigation Sensor.
NOTE: All saved waypoints, routes, MOB events, tidal ports and DGNSS Messages will
also be deleted from the system!
Figure 123
– Restore Config
