R5
SUPREME - Navigation System
CONFIGURATION
7000 118-383, P11A1
Page 109
WPT/RTE Data Port
This view is accessed by pressing
Main
Maintenance
Configuration
Interface
Input
Depth Data Port
Parameter Name
Description
Input Port
Specifies the input port that should be used for input of
waypoints and routes. Can be set to Input Port 1
5
or
“Any”.
Waypoints and routes received on a port that does not
correspond to this setting will be ignored.
Input Sentence
This parameter makes it possible to only use a specific
NMEA sentence for routes.
Input of routes with Rnn-sentence will always be
considered as a “working” route i.e. it will replace the
current active route in the system.
Input of routes with RTE-sentence can either mean
working route or complete route depending on
information in the RTE-sentence. A working route will
replace the currently active route. A complete route will
be added to the route database. If a route with the
same name already exists in the database, the existing
route will be overwritten with the new route.
All legs of the route will use the default settings of Nav-
Algorithm, RAIM level and XTE Limit as configured in
the
Navigation Config
View (
see section 10.1.1
).
Input Talker ID
This parameter makes it possible to only use
sentences from a specific talker (having a specific
NMEA talker ID) for the waypoint and route data.
Sensor Input Function
This view is accessed by pressing
Main
Maintenance
Configuration
Interface
Input
Sensor Input Function
Parameter Name
Description
In 1, In 2, In 3, In 4, In5
Specifies if the input port shall be used to receive
“NMEA” messages and correction data, or if it shall act
as an “Alarm Acknowledgement” reacting on external
switching.
