R5
SUPREME - Navigation System
CONFIGURATION
7000 118-383, P11A1
Page 105
Calibration
This view is accessed by pressing
Main Menu
Maintenance
Configuration
Calibrate Display
Figure 100
– Calibration View
Press on the crosshair each time it appears to calibrate the touch screen. Try to hit the centre
of the cross as accurate as possible for the best possible calibration. When the calibration is
done, a test screen will appear where the new touch settings can be tested. Press anywhere
on the screen to move the crosshair. Accept the new calibration by pressing ENTER on the
keypad or press ESC to re-calibrate.
NAV Alarm
This view is accessed by pressing
Main Menu
Maintenance
Configuration
Alarm
NAV Alarm
In this view all alarms can be configured to either “Enabled” or “Disabled”. When the alarm is
enabled, an active alarm will trigger the external alarm discrete output signal, activate the
internal speaker in the R5 SUPREME CDU and a popup dialog will appear.
NAV Port Rates
This view is accessed by pressing
Main
Maintenance
Configuration
Interface
Port Rates
NAV Port Rates
In this view it is possible to configure the individual baud rate for the five input- and eight
output ports in the R5 Navigation System, as well as the pulse rate of the Speed Log output.
