S2Konnect S-8180T
9
Make sure that the wall is capable of supporting the S2Konnect Unmanaged Switch.
The S2Konnect Unmanaged Switch must not be exposed to direct sunlight or be installed near
heating vents. The location should be ventilated to prevent overheating.
Installation in a Rack
To install the S2Konnect Unmanaged Switch in a rack, proceed as follows:
1.
Attach the brackets at each side of the S2Konnect Unmanaged Switch using the supplied
screws.
2.
Insert cage nuts into the mounting rail of the rack.
3.
Hold the S2Konnect Unmanaged Switch against the rack ensuring that the bracket holes
align with the holes of the rack.
4.
Screw the S2Konnect Unmanaged Switch on the rack using the supplied screws.
5.
Tighten the screws.
6.
Plug in the power cord.
7.
Turn on the S2Konnect Unmanaged Switch.
The green Power LED should light up indicating that the power supply is ok.
The S2Konnect Unmanaged Switch can be installed in racks, which are at least 48.3cm/19 in-
ches deep.
Figure 2. Rack Installation
i
i
