79-15259-00
www.srsmith.com
Page 5 of 7
Hooking up 12VAC Light to Circuit 1
To connect a 12VAC light to the Circuit 1
switch, pull wires from the low voltage lighting
product to the SRS-TX-30 through conduits
connected to the left bottom of the SRS-TX-30.
Some lights may identify a 12VAC Hot and
Neutral lead though this is not typical with
12VAC low voltage lighting as there is no
polarity. If it does identify specific leads, then
follow the below instructions.
As illustrated, connect the light that will be
operated by the Rocker Switch to the Light Hot
terminal. Connect the Light Neutral to the
Light Neutral terminal. Do not exceed demand
of 30 watts @ 12V.
Two UL listed wire nuts have been included to
simplify connection of up to five lights to the
terminal strip.
If conductors are stranded
18AWG wire or smaller, use a crimping tool
and the supplied copper wire ferrules for a
secure installation.
LIGHT HOT, 12VAC
LIGHT NEUTRAL, 12VAC
ON
OFF